免费日本综合国产-亚洲日本韩国成人在线视频-欧美日韩中文字幕高清在线-午夜麻豆国产精品无码不卡,国产高清一级在线观看,精品色婷婷亚洲十月十月色天,亚洲欧美日韩中文字幕一区二区



      

      



      


          

      

      

 
      

      
    
      
    
      
    Principle of formula design of friction plate

      
    
      
    
      
    Published:

      
    
      2022-11-23
      

      
    
      wangda
      


      

      
    
      The friction plate achieves various properties of the product through the ratio of various friction materials by the R&D personnel. In the ratio, the R&D personnel will use the comprehensive ratio of various materials instead of adding them in large proportion for a certain performance, which will make the friction plate produced cannot be used normally. The proportion of friction materials is required by certain requirements, and we will talk about the principles below.
      


      1. Scientific principle:
      


      (1) Meet the performance requirements of friction plate.
      


      (2) Understand the physical, chemical and structural characteristics of friction materials
      


      (3) Pay attention to the influence of coordination on product quality
      


      (4) Pay attention to the amount limit of various friction materials
      


      (5) Various collocation of low-cost friction materials
      


      (6) Use of additives
      


      (7) The typical formula can not be used mechanically
      


      2. Economic principle:
      


      (1) On the premise of meeting the service performance of the friction plate, the friction materials with lower price shall be selected as far as possible
      


      (2) Develop local friction material resources and obtain materials nearby
      


      (3) The formula is applicable to the process method with simple process, high productivity, short production cycle, less energy consumption and material consumption, and less investment
      


      3. Principle of legality:
      


      There are two kinds of product standards issued by the state, one is recommended standards, the other is mandatory standards.